More stringent emissions regulations usually add more equipment onboard. However, the amount of equipment that can be added to the engine room and the amount of time that the crew has remaining for new operations are both limited.
Combining treatment units for different waste streams is one way to overcome this challenge, and even though a combined system for bilge, black and grey water is technically possible, there are too few common denominators for effluent water parameters. For separate waste streams with identical effluent discharge requirements, it is a whole new ballgame.
The oil content (below 15 ppm) is the only regulated parameter for discharge of either MEPC.307(73) regulated EGR bleed off water mor MEPC.107(49) regulated bilge water. It therefore made perfect sense to develop a treatment system that can treat both.
The Marinfloc, class approved, combined EGR bleed off water and bilge water treatment system is the first solution ever to treat waste streams belonging to various Marpol annexes. By integrating the WhiteBox® and segregation valves, the requirement not to mix Marpol ANNEX I and VI waste and recording of discharge data in the oil record book and the EGR record book, are fulfilled.
A combined treatment system for EGR bleed-off water and bilge water is a convenient installation to minimize the cost of both equipment and installation related to the discharge of bilge water and EGR bleed-off water. Bilge water and EGR bleed-off water belong to different Marpol annexes and must hence be kept segregated, and there must be separate holding tanks and sludge tanks. The system segregation valves prohibit mixing of the two, including the generated sludge from the treatment process. The class approved automated switch-over sequence with interlocks is controlled by the system automation. From the control panel, the operator can easily select which waste stream to treat. The WhiteBox® will control and record the system vital discharge parameters and segregate the amount of discharged bilge water and EGR bleed-off water for separate record keeping as required.
Process description: The CD-unit can take suction from either the EGR bleed-off tank or the Bilge water holding tank. Three three-way valves connected to a selector switch secure that the waste streams are never mixed. The EGR bleed-off water is collected in a bleed-off water drain tank of a cascade type. The tank should be equipped with heating coils to heat the bleed-off water to 40-55 °C, solid sensors that will detect solidification of soot. The system must have segregated sludge tanks as per the Marpol requirements. The wastewater is treated overboard through a WhiteBox® by the CD unit and all vital system data such as tank levels, valve positions, oil content, discharged volume etc. is recorded and logged in the WhiteBox® recorder.
Contact us for more information.
Key Features of Combined EGR and Bilge Water Treatment System
- Lower CAPEX as there is no need to procure a separate OWS.
- Lower OPEX, less documentation, classification cost and spare parts.
- Space-efficient with a smaller footprint.
- One high-end separator for two waste streams.
- Lower cost for commissioning.
Advantages of Marinfloc OWS system
- Flocculation technology. No cartridge filters nor centrifuges required.
- Adjustable to the ship specific EGR bleed-off water composition
- Low energy consumption for low carbon footprints
- Low operational cost
- Stainless steel material
- Made in Sweden
- MEPC.307(73) regulated EGR bleed off water
- MEPC.107(49) regulated bilge water
Contact us for more information. firstname.lastname@example.org